THE AUDITORY MODELING TOOLBOX

Applies to version: 0.9.8

View the code

Go to function

sig_breebaart2001 - computes the signals for the breebaart2001 experiment

Usage

signalout = sig_breebaart2001(inttype,fc,sl,sdur,sphase,nbw,nl,ndur,nphase,hannramp,fs)

signalout = sig_breebaart2001(inttype,fc,sl,sdur,sphase,nbw,nl,ndur,nphase,hannramp,fs) generates the signals for the breebaart2001 experiment where sinusoidal signals are masked by noise. 'inttyp' determines if it is a target interval (signal + noise) or just a reference interval (noise only). The sinusoidal has a center frequency of 'fc' (in Hz), an overall level of 'sl' (in dB SPL), a duration of 'sdur' (in seconds) and an interaural phase difference of 'sphase' (in rad). The masker is generated at a center frequency 'fc' in Hz, with a bandwidth of nbw (in Hz), duration ndur (in sec), overall level nl (in dB SPL) and an interaural phase difference of 'nphase'. Both signal and masker are gated with hanning ramps with a duration of 'hannramp' (in s). The sampling rate is defined with fs (in Hz).

Input parameters

'',inttyp 'target' or 'reference' defines the interval type
'',fc center frequency
'',sl overall signal level
'',sl duration of the signal
'',sphase interaural phase difference of signal
'',nbw bandwidth of the noise
'',nl overall noise level
'',ndur duration of the noise
'',nphase interaural phase difference of noise
'',hannramp duration of the hanning ramps
'',fs sampling frequency
The following parameters for 'nphase' are possible:
'nphase' = 0 no phase difference, correlation = 1; 'nphase' = pi masker interaurally phase reversed, correlation = -1; 0 < 'nphase' < 1 defines interaural correlation

Output parameters

'',signalout the generated experimental signal which can be feeded directly into the model

References:

J. Breebaart, S. van de Par, and A. Kohlrausch. Binaural processing model based on contralateral inhibition. II. Dependence on spectral parameters. J. Acoust. Soc. Am., 110:1089-1104, August 2001.